ATmega328 12MHz : Adafruit Pro Trinket 3V.ATmega328 16MHz : Arduino UNO, Adafruit Pro Trinket 5V, Adafruit Metro 328, Adafruit Metro Mini.More information on the ADX元45 can be found in the datasheet: Compatibility MCU The Adafruit_ADX元45 driver takes advantage of I2C mode to reduce the total pin count required to use the sensor. The ADX元45 is a digital accelerometer that supports both SPI and I2C mode, with adjustable data rata and 'range' (+/-2/4/8/16g).

Tested and works great with the Adafruit ADX元45 Breakout BoardĪdafruit invests time and resources providing this open source code, please support Adafruit and open-source hardware by purchasing products from Adafruit! About the ADX元45 Please help.This driver is for the Adafruit ADX元45 Breakout ( ), and is based on Adafruit's Unified Sensor Library (Adafruit_Sensor). I'm frustrated and behind schedule on this project. I've also tried 'Sketch -> Upload Using Programmer' and two other Trinkets. I've also tried uploading immediately after the red light stops. The error occurs while the red light is still blinking on the Trinket. I push the reset button and then upload on the IDE. I've changed the programmer to USBtinyISP. I've tripple checked the Adafruit configuration. After more googling I found other threads on this forum. After googling around I realized that USB 3 could be a problem, so I got a USB 2 hub into the chain. So far I've only got the trinket connected to USB. I'm just trying to get the code to upload to the trinket. I'm working on the Neopixel Goggles from the getting started book (chapter 5, example 3).

How to wire adafruit trinket 5v guide